Ford Tractor 8N Rebuilt Governor With Instruction Book9

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Ford Tractor 8N Rebuilt Governor With Instruction Book9:
$124.95

Here is a great conditionrebuilt governor for a Ford 8N tractor without proof meter drive. The internal bearings were replaced along with the governor balls and control shaft seal. All the other items were checked for wear and factory tolerances were reset. The external case mounting face was flat ground toprevent leakage. Paint was striped and is primed with etching primer to allow your finish coat of paint to stick to the aluminum. Included is a new gasket and a scanned copy on CD of the original Ferguson systems, Maintenance & Repair of The Governor and Control Linkage. This has all the instructions and trouble shooting you will need to set factory speeds and linkage settings. This is a very good book to have if you have a N tractor. This governor has the Factory throttle stop screw in the back. The book dose not cover this but it is an adjustment on a rare few so you can adjust in to reduce the travel of the conical shaped race which will adjust and limit the amount of travel to the throttle butterflyin the carburetor.I have the screw backed away allowing full function of the governor. Don\'t just buy another used governor and hope for the best. Shipping will be a $9.95 USPS priority mail. Use the Buy it now and get Free Shipping.E-mail me with any questions you might have & Thanks for Looking!

We PREFER Paypal so we can get your Items to you as soon as possible. Please do not offer if you can not have payment to me before ten days of close of sale. I WILL SEND A BILLING INVOICE AT THE END OF THE sale. BUYERS MUST REPLY WITHIN 2 DAYS WITHINSTRUCTIONS OF WHENPAYMENT CAN BE EXPECTED. Prompt payment means positive response. Good Luck!